BT UC-351GP/E-UK Manual de instalación descargar pdf (Pagina 16)

BT Redcare Secure Issue 16 June 2010

Configuring Panel Format

By default the unit is configured for pin-only mode. This mode disables the dial capture port to

reduce power consumption. Use the following command to enable the dial capture port and set it

to receive the relevant panel format where dial capture is required. Note Pins can still be reported

in any of these other modes.

To change the panel format, use the * 15 * option:

* 15 * 1 # ContactID

* 15 * 10 # High Speed (fast format)

* 15 * 20 # SIA

* 15 * 30 # Pin Only mode - default

The Redcare Secure unit supports several other less common formats listed below:

* 15 * 2 # ContactID with Double Knock

* 15 * 3 # 4 + 1 express (DTMF mode only)

* 15 * 5 # 4 + 2 express (DTMF mode only)

* 15 * 11 # High Speed with Double Knock

* 15 * 21 # SIA with V21 tones

If no more parameters are to be configured, remove the header from J903 and disconnect the

DTMF phone.

Configuring General Purpose Outputs

By default, the Redcare Secure unit‟s General Purpose Outputs (GPOP‟s) operate as follows:

Output

Default Function

Default Polarity

GPOP1

Local path fail output

High to indicate dual path

failure.

GPOP2

Remotely (ARC) Controlled

0 from ARC sets output High, 1

from ARC sets output Low

GPOP3

RPS function (in conjunction with input pin 4)

Alarm sent sets output High,

Alarm ack‟d sets output Low

Figure 11 - General Purpose Output Pin operations

The following commands can be used to configure the behaviour of the GP Outputs:

GPOP1

* 91 * 20 BSIA Form 175 Mode – default mode

* 91 * 30 Standard Path Fail Mode Active Low (Failure of any communications path causes a

Low on GPOP1)

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Sin comentarios

BT UC-351GP/E-UK Manual de instalación Pagina 16