BT UC-351GP/E-UK Manual de instalación descargar pdf (Pagina 22)

BT Redcare Secure Issue 16 June 2010

7 Network Registration and Commissioning

Ensure both Config and learn headers are removed.

If Config Header (J903) is shorted, the unit will not attempt to register on the BT Redcare

Enterprise Service Platform (ESP). The header short should be removed once configuration is

complete.

Network Registration

On startup, the unit will immediately attempt to register on the BT Redcare ESP with all available

interfaces:

- GPRS

- PSTN or Ethernet

During registration and also in normal operation, the meaning of the LED indications is as follows:

State

Wireline (LED 2)

Wireless (LED 3)

Off

Either:

The unit is in the process of starting up

or:

The wireline path is not available.

i.e. Ethernet port cannot obtain an IP

address or PSTN path was unable to

complete the last dial up attempt)

Either:

The unit is attempting to obtain an IP

address

or:

The wireless interface is not available

Slow Flash

1s Off 1s On

The Unit is attempting to set up an IP

path to the ESP. (i.e. Ethernet port has

obtained an IP address and is

attempting to reach the ESP. Or PSTN

is attempting to establish a dial up call)

The unit has an IP address over its

wireless (i.e. GPRS) interface and is

attempting to contact the ESP

Fast Flash

250ms Off

250ms On

PSTN path has a call in progress and is

communicating with the ESP

N/A

Blink

50ms On

950ms Off

PSTN path has detected PSTN voltage

fail < 1.5V on PSTN

N/A

The unit is connected to the BT Redcare

ESP via IP, or the last PSTN dial up call

was successful.

The unit is connected to the BT

Redcare ESP via GPRS

Figure 14 - Wireline and Wireless LED indications

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Comentarios a estos manuales

Sin comentarios

BT UC-351GP/E-UK Manual de instalación Pagina 22

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad BT UC-351GP/E-UK